Commercial Service Plans
Green Synergy offers our commercial and industrial customers the option of purchasing annual Service Plans. These Service Plans not only cover regularly scheduled maintenance, but they also provide a significant discount on service calls and repairs. They are a great way to keep your system operating at peak performance and protect you against the expense of a major repair. The Service Plans include:
- Annual Safety Inspection
- Free Emergency Diagnostic
- Minimum 10% Savings on Parts / Service
- 10% Savings on Duct Cleaning / Electrical Work
- Priority on Emergency Repairs
- Discounts on Purchase of Commercial Comfort Systems, Water Heaters, and Generators
All of our work is backed by the Green Synergy Quality Assurance Guarantee. When you call Green Synergy, you will always receive quality workmanship and superior customer service.
Our Service Plans Cover:
- Test for Carbon Monoxide Leaks
- Clean Ignition Assembly
- Inspect Hot Water Heater
- Inspect Flue Draft and / or Inducer Motor
- Oil the Inducer and Blower Motors
- Inspect Burner
- Measure Volt Amps on all Motors
- Inspect / Tighten Electrical Connections
- Inspect / Lubricate Blower
- Test Safety Controls
- Inspect Thermostat
- Inspect Humidifier
- Inspect Filters / Electronic Air Cleaner
- Clean Flame Sensor
- Check Heat Exchanger for Carbon Monoxide
- Check Operation of Carbon Monoxide Detector
- Inspect Pilot Assemblies
- Inspect Condensate Drain
- Replace Air Filter / Humidifier Pad (if necessary)*
* Extra Cost May Apply
For boilers, we also:
- Inspect All Controls
- Check Low Water Cut Off
- Inspect Safeties
- Lubricate Pump
- Inspect Site Glass
- Cycle All Shut Off Valves
- Inspect Water Heater
- Inspect Water Supply Lines
- Inspect Washing Machine Hoses
- Check Pipe Anchoring
- Check Drain Installation
- Flush Floor Drains
- Inspect Humidifier / Ice Maker Valves
- Check Toilet Tank Water Level
- Inspect Dishwasher Drain Line
- Test Operating Pressures
- Check for Leaks
- Clean Condenser Coil
- Oil Motors
- Inspect Evaporator Coil for Proper Drainage
- Measure Volt Amps on all Motors
- Inspect Condensate Pump
- Check Filter
- Check Amp Draw of Unit
- Inspect Blower Belt
- Check if Unit is Level
- Check Air Temperature Differential
- Shut Down Humidifier
- Inspect Thermostat
- Check Heat Exchanger for Carbon Monoxide
- Replace Air Filter (if necessary)*
* Extra Cost May Apply
- Inspect Exterior Service Equipment
- Cycle Disconnects and Remove Pullouts
- Inspect Meter Socket
- Check Ground Rods
- Inspect Service Panel
- Trip and Reset GFIC / AFIC Devices
- Cycle all Switches
- Check Polarity
- Check for Code Violations
